ASCO Torch Blog
High Temperature Torch Kits Vs Low Temperature Torch Kits January 17 2015
In a previous article we talked about the differences between using Oxy/Acetylene torches and regular Air/Acetylene torches Now that we have established that although some guys prefer using Oxy/Acetylene torches, the easier and more economical way to braze and solder is with the more conventional Air/Acetylene torches.
That being said this article will deal with the differences between using a high temperature “Turbo” type torches and a low temperature “Prestolite” type torches. There are 2 basic ways to join copper and brass to themselves and each other. Brazing and Soldering. It is in this area that we are discussing the differences in the high and low-temperature tips.
Let’s look at some of the differences between Torch Kits.
High-temperature tips offer the following attributes:
- Generally burn at a temperature of 2500 to 2700 degrees
- Have a short hot flame that is designed to wrap around the fitting
- Use more gas than the low-temperature outfits
- Are usually of the quick disconnect design
- Have a high pitch whistle
Low-temperature tips offer the following attributes:
- Generally burn at as temperature of 1500 degrees
- Have a longer more brush like flame
- Use less gas than high-temperature tips
- Are usually of the screw-in design
- Much quieter than the high-temperature tips
Since brazing takes place at approximately 900 degrees the high-temperature tips would seem to be the more logical choice. Whereas both tips will reach the target temperature, remember it’s the temperature of the material being brazed that has to reach the brazing temperature. That being said, the higher the temperature of the flame the quicker the base material will reach the correct temperature needed for brazing to take place. High heat is also necessary for good adhesion and capillary action to occur when using silver-based solder.
Soldering occurs at approximately 400 degrees. This means that far less heat is necessary for soldering to occur. The low-temperature tips would be a better fit in these applications. Since less heat is needed the low temp tips will use less gas making them more economical to use. When doing service work generally the low-temperature tips are the better choice in that you are only soldering a couple of joints.
The problem with either application is that the high-temperature tips come with a quick disconnect design and the low-temperature tips are of a screw-in design.
The easy solution to this is at www.ascotorch.com where you can get both the high-temperature and low-temperature tips in both screw-in and quick disconnect designs.